水分对高碱值硫化烷基酚钙结构和清净性的影响

采用傅立叶红外光谱仪，分析了水分对清净剂高碱值硫化烷基酚钙结构组成的影响；采用热管氧化试验法和曲轴箱模拟试验法，考察了高碱值硫化烷基酚钙在加水前后清净性能的变化；采用四球试验机和高频往复试验机，分析了水分对高碱值硫化烷基酚钙润滑性能的影响。结果表明，油中的水含量对高碱值硫化烷基酚钙的水解安定性能影响较大，并且随着水含量的增加，油品的清净性能和抗磨性能变差。     

中碱值硫化烷基水杨酸钙的制备及性能研究

介绍了一种碱值达170mgKOH／g以上、硫含量大于3．0％、钙含量大于6．0％的硫化烷基水杨酸钙盐润滑油添加剂的制备过程及其性能。实验中重点考察了促进剂及硫磺加入量对产品碱值及硫含量的影响；通过冷冻蚀刻电镜法观察了含碳酸盐的胶体粒子结构及粒度分布情况；应用凸轮挺校、四球试验机等考察了硫化烷基水杨酸钙盐产品的极压抗磨性能。结果表明，硫化烷基水杨酸钙产品不但具有良好的高温洁净性、抗氧化安定性、胶体稳定性，而且具有突出的极压抗磨性及热稳定性。     

真空钙热还原炉渣的综合利用研究

研究了从真空钙热还原炉渣中回收稀土的工艺条件；采用本工艺得到的合格稀土溶液，其回收率达65．41％；副产品氟化钙用作炼硅铁合金的助熔剂，使钙热还原炉渣得到综合利用。     

The flame retardant mechanism of polyolefins modified with chalk and silicone elastomer

This paper presents the current understanding of the flame retardant mechanism of Casico?. The study includes the flame retardant effect of each individual component: ethylene–acrylate copolymer, chalk and silicone elastomer, as well as the formation of an intumescent structure during heating. The flame retardant properties were investigated by cone calorimetry and oxygen index tests. To obtain insight into the flame retardant mechanism, heat treatment under different conditions has also been performed. The results indicate that the flame retardant mechanism of Casico is complex and is related to a number of reactions, e.g. ester pyrolysis of acrylate groups, formation of carbon dioxide by reaction between carboxylic acid and chalk, ionomer formation and formation of an intumescent structure stabilized by a protecting char. Special emphasis is given to the formation of the intumescent structure and its molecular structure as evaluated from ¹³C MAS‐NMR and ²⁹Si MAS‐NMR, ESCA and XRD analysis. After treatment at 500°C the intumescent structure consists mainly of silicon oxides and calcium carbonate and after treatment at 1000°C the intumescent structure consists of calcium silicate, calcium oxide and calcium hydroxide. Copyright © 2003 John Wiley & Sons, Ltd.     

腐殖质对重金属离子的吸附作用

采用腐殖质对重金属离子进行了吸附试验。其结果表明 ,腐殖质对重金属离子具有强烈的吸附作用。腐殖质对Cu2 + 、Zn2 + 、Cd2 + 的吸附边界pH值分别为 4 2 ,5 8,7 2 ,吸附率可达 95 %以上 ;对Pb2 + 的吸附作用更加强烈 ,在pH值为 3 5时吸附率就达到 95 %以上 ,并且随着pH值的升高吸附率仍在 95 %以上。腐殖质对 4种重金属离子的吸附能力由强到弱的顺序是Pb2 + >Cu2 + >Zn2 + >Cd2 + 。腐殖质可以用来处理含重金属离子的污水 ,具有过滤快、沉降稳定、效果好的优点 ;也可作为土壤改良剂 ,有效地降低土壤中重金属的含量     

部分种子成分的特征X射线在等效生物材料中衰减的测定

用Ｓｉ（Ｌｉ）探测器实现了Ｎａ、Ｍｇ、Ｓ、Ｃｌ的特征Ｘ射线在有机膜中的相对衰减以及与Ｏ、Ｋ元素的特征Ｘ射线能量相当的Ｘ射线或轫致辐射在有机膜中的相对衰减，分别得出了它们减的数学描述，并把实验得到不同能量的Ｘ射线在有机膜中的质量吸收系数与Ｂｅｒｋｅｌｅｙ的ＯＣＧ软件计算出的结果相比，相关都小于３０％。     

水稻花后衰退珠心和胚乳发育初期Ca2+的超微细胞化学定位

应用焦锑酸盐沉淀技术对水稻花后衰退珠心和胚乳发育初期进行了Ca^2 的超微细胞化学定位。结果显示在初始衰退的珠心细胞中Ca^2 主要分布于液泡膜上和核内；在衰退中期的珠心细胞中，Ca^ 主要分布在核膜、液泡膜及质膜上；在严重衰退的珠心细胞，Ca^2 仅存在于液泡中。珠心降解的Ca^2 跨过胚囊壁，通过质外体向胚乳内运输；发育初期的胚乳细胞，Ca^2 主要位于胞间隙，线粒体和液泡中也有少量分布。讨论了Ca^2 与珠心PCD的关系。     

饲料用脱氟磷酸钙的生产

本文介绍了饲料用脱氟磷酸钙生产现状，建议采用钠盐－磷酸法工艺。     

Absorbability of Calcium From Common Beans

Absorption of calcium from white, red, and pinto beans, labeled with ⁴⁵Ca, was measured in 24 women in a three-way randomized design using a calcium load of 72 mg and milk as the referent. Fractional absorption for the three beans averaged 0.219 ± 0.047 and did not differ by type. Milk calcium absorption at the same load was more than two times higher, 0.451 ± 0.088 (P < 0.001). Oxalate content averaged 0.34%, and phytate averaged 1.7%, a stoichiometric excess relative to calcium. To evaluate the relation of phytate to reduced absorbability, labeled pinto beans were pre-treated with phytase and fed to 10 subjects. Fractional absorption rose, averaging 0.318 ± 0.071, (P <0.01 vs. untreated beans), but was significantly below that of milk. The difference was partly accounted for by phytate, with the remainder probably due to relatively high oxalate.     

The chloride stress-corrosion cracking behavior of stainless steels under different test methods

Chloride-induced stress-corrosion cracking (SCC) is one of the failure modes of stainless steels. Highly alloyed austenitic stainless steels S32654, S31254, and N08028, and duplex grades S32750 and S31803 possess much improved resistance to SCC compared with S30400 and S31600 steels. With the development of a database, SSData, experimental data collected from calcium chloride tests, autoclave tests, and drop evaporation tests were evaluated. Stress-corrosion cracking data generated by autoclave tests agreed well with the practical service conditions and can be used to discriminate alloys for SCC resistance in sodium chloride solution. Drop evaporation test data can be used in situations where evaporation may occur and cyclic loading may be involved. The SCC resistance of alloys under each method increased with increasing molybdenum equivalent Mo + 0.25Cr + 0.1Ni. For a given alloy, the testing result depends on the stress state and environment; different test methods can give different ranking orders concerning SCC resistance. The performance of duplex stainless steels in a chloride-containing environment at higher temperatures was not as good as expected when dynamic loading was involved.